Universal Bed camera mount - fully printed

Camera mount for printer bed
Fully printed

1/4" screw on ball (screw was resized a little after print, its was not tested again but should fit).

6 clip models
Original (should be stronger but will not fit well in some cases) and rounded simplified.
Small should fit the bed 0.8mm (+/- 0,2), normal ~1,4mm (+/- 0,2), very small ~0.4mm

edit 2020.II.18
Added 2 smaller gap clip models.

edit 2020.II.20
Added Clamp with screw, as more universal holder, and a base model without ball if you want to record from lower height (but without being able to change the angle) and to use less filament to.
Both clamp screw and base screw should be printed with 100% infill for more strenght