Thingiverse
Wire Holder
von Aaron5
6
Downloads
5
Likes
0
Makes
A wire holder that is 10cm in diameter. The pole is 10mm thick so you can replace with a normal pole should you wish to have a longer pole than your printer can print.
There are a few holders uploaded:
- One has M3 fixing holes 90mm apart.
- The other mounts directly onto the desk draw (probably not useful to many).
I suggest you print the spools with no outer layers as it makes print time much quicker, see image for comparision.
As an example the spool on the right of the holder has 50m of 30awg wire on it.
The pole in the design should be able to hold 7 spools.
You may need to use a clamp to get the two spool halfs to push together fully. Once together they dont come apart or require glue.
There are a few holders uploaded:
- One has M3 fixing holes 90mm apart.
- The other mounts directly onto the desk draw (probably not useful to many).
I suggest you print the spools with no outer layers as it makes print time much quicker, see image for comparision.
As an example the spool on the right of the holder has 50m of 30awg wire on it.
The pole in the design should be able to hold 7 spools.
You may need to use a clamp to get the two spool halfs to push together fully. Once together they dont come apart or require glue.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
