Thingiverse
Wire stripper
von dragon1020
12.1k
Downloads
8.8k
Likes
117
Makes
Wire stripper. Not very beautiful (this is too big blade for this tool), but works well. All you need is M3 screw, M3 nut, and utility blade.
UPDATE: Made version 2 - stronger and without useless trigger. :) I suggest to use supports while printing for M3 nut hole, but some folks says, that it prints fine without using supports.
HINT: You can strip really thin wires (for example from servo motor or RC flight controller (0.8 mm in diameter with insulation)) with last third of the blade, near ring for finger.
UPDATE: Made version 2 - stronger and without useless trigger. :) I suggest to use supports while printing for M3 nut hole, but some folks says, that it prints fine without using supports.
HINT: You can strip really thin wires (for example from servo motor or RC flight controller (0.8 mm in diameter with insulation)) with last third of the blade, near ring for finger.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
