Thingiverse
Wire stripper
door dragon1020
12.1k
Downloads
8.8k
Likes
117
Makes
Wire stripper. Not very beautiful (this is too big blade for this tool), but works well. All you need is M3 screw, M3 nut, and utility blade.
UPDATE: Made version 2 - stronger and without useless trigger. :) I suggest to use supports while printing for M3 nut hole, but some folks says, that it prints fine without using supports.
HINT: You can strip really thin wires (for example from servo motor or RC flight controller (0.8 mm in diameter with insulation)) with last third of the blade, near ring for finger.
UPDATE: Made version 2 - stronger and without useless trigger. :) I suggest to use supports while printing for M3 nut hole, but some folks says, that it prints fine without using supports.
HINT: You can strip really thin wires (for example from servo motor or RC flight controller (0.8 mm in diameter with insulation)) with last third of the blade, near ring for finger.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!