Thingiverse
Xbox controller Wall Mount
von beerman_uk
51
Downloads
37
Likes
0
Makes
Remixed as the original had quite a chunky profile.
The arms have been given an extra 2mm as the original ones were a bit flimsy.
Works with the headset adaptor and fits the edge of an Ikea lack table perfectly (although it can go anywhere).
Update:
I've added the inserts for the xbox logo. Just print them off and push fit them in place. I needed to sand a thin bit off each edge but then just used the butt of a screwdriver to hammer them in place. I just wish I had some green filament :)
UPDATE:
I have added 2 more screw holes due to the legs pulling on the top of the frame which pulls it away from the wall/table. Also reversed one of the legs due to the same reason.
The arms have been given an extra 2mm as the original ones were a bit flimsy.
Works with the headset adaptor and fits the edge of an Ikea lack table perfectly (although it can go anywhere).
Update:
I've added the inserts for the xbox logo. Just print them off and push fit them in place. I needed to sand a thin bit off each edge but then just used the butt of a screwdriver to hammer them in place. I just wish I had some green filament :)
UPDATE:
I have added 2 more screw holes due to the legs pulling on the top of the frame which pulls it away from the wall/table. Also reversed one of the legs due to the same reason.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
