Thingiverse
Xbox controller Wall Mount
par beerman_uk
51
Téléchargements
37
Likes
0
Makes
Remixed as the original had quite a chunky profile.
The arms have been given an extra 2mm as the original ones were a bit flimsy.
Works with the headset adaptor and fits the edge of an Ikea lack table perfectly (although it can go anywhere).
Update:
I've added the inserts for the xbox logo. Just print them off and push fit them in place. I needed to sand a thin bit off each edge but then just used the butt of a screwdriver to hammer them in place. I just wish I had some green filament :)
UPDATE:
I have added 2 more screw holes due to the legs pulling on the top of the frame which pulls it away from the wall/table. Also reversed one of the legs due to the same reason.
The arms have been given an extra 2mm as the original ones were a bit flimsy.
Works with the headset adaptor and fits the edge of an Ikea lack table perfectly (although it can go anywhere).
Update:
I've added the inserts for the xbox logo. Just print them off and push fit them in place. I needed to sand a thin bit off each edge but then just used the butt of a screwdriver to hammer them in place. I just wish I had some green filament :)
UPDATE:
I have added 2 more screw holes due to the legs pulling on the top of the frame which pulls it away from the wall/table. Also reversed one of the legs due to the same reason.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
