Thingiverse
yet another cable guide
by lentchr
0
Downloads
0
Likes
0
Makes
requires a m3 shoulder bolt and a 5x13x4 bearing.
There is a hole on the bottom of the mounting bracket in case i ever wanted to add a guard around the wheel to keep it from falling off but it hasn't skipped the wheel yet. It might be able to be used for a filament run out sensor.
the mounting bracket is best printed on its back with support in the overhang gap, on its top would not be very structurally sound.
There is a hole on the bottom of the mounting bracket in case i ever wanted to add a guard around the wheel to keep it from falling off but it hasn't skipped the wheel yet. It might be able to be used for a filament run out sensor.
the mounting bracket is best printed on its back with support in the overhang gap, on its top would not be very structurally sound.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
