Thingiverse
yet another cable guide
von lentchr
0
Downloads
0
Likes
0
Makes
requires a m3 shoulder bolt and a 5x13x4 bearing.
There is a hole on the bottom of the mounting bracket in case i ever wanted to add a guard around the wheel to keep it from falling off but it hasn't skipped the wheel yet. It might be able to be used for a filament run out sensor.
the mounting bracket is best printed on its back with support in the overhang gap, on its top would not be very structurally sound.
There is a hole on the bottom of the mounting bracket in case i ever wanted to add a guard around the wheel to keep it from falling off but it hasn't skipped the wheel yet. It might be able to be used for a filament run out sensor.
the mounting bracket is best printed on its back with support in the overhang gap, on its top would not be very structurally sound.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
