Thingiverse
Adjustable BLTouch sensor mount
von FFranzmann
19
Downloads
11
Likes
2
Makes
Adjustable mount for BLTouch.
Parts needed:
1 M4 screw for leveling,
1 spring (not to weak)
1 Injection nut M4 outer diameter 6mm
1 M4 washer (goes between screw head and plastic of course)
Fit is quite tight so maybe you need to adjust the base a little bit upwards or file the hole a bit bigger.
The BLTouch_base_sideway can be used on the lulzbot taz 6 X-carriage.
The BLTouch_mount_max_lenght is the maximum lenght you can use.
Print in
Parts needed:
1 M4 screw for leveling,
1 spring (not to weak)
1 Injection nut M4 outer diameter 6mm
1 M4 washer (goes between screw head and plastic of course)
Fit is quite tight so maybe you need to adjust the base a little bit upwards or file the hole a bit bigger.
The BLTouch_base_sideway can be used on the lulzbot taz 6 X-carriage.
The BLTouch_mount_max_lenght is the maximum lenght you can use.
Print in
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
