Thingiverse
Adjustable BLTouch sensor mount
by FFranzmann
19
Downloads
11
Likes
2
Makes
Adjustable mount for BLTouch.
Parts needed:
1 M4 screw for leveling,
1 spring (not to weak)
1 Injection nut M4 outer diameter 6mm
1 M4 washer (goes between screw head and plastic of course)
Fit is quite tight so maybe you need to adjust the base a little bit upwards or file the hole a bit bigger.
The BLTouch_base_sideway can be used on the lulzbot taz 6 X-carriage.
The BLTouch_mount_max_lenght is the maximum lenght you can use.
Print in
Parts needed:
1 M4 screw for leveling,
1 spring (not to weak)
1 Injection nut M4 outer diameter 6mm
1 M4 washer (goes between screw head and plastic of course)
Fit is quite tight so maybe you need to adjust the base a little bit upwards or file the hole a bit bigger.
The BLTouch_base_sideway can be used on the lulzbot taz 6 X-carriage.
The BLTouch_mount_max_lenght is the maximum lenght you can use.
Print in
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
