Thingiverse
Adjustable Tablet Stand
von SubSite
18
Downloads
12
Likes
0
Makes
A sleek stand that should fit most tablets. Tilt angle adjustable with screw. Prints without supports.
Make sure you print it lying on its side, like it is in the file.
The "Low edge" version is for minimizing screen obstruction on devices with very thin edges around the screen. If you think this might apply to you, print the "edge tester" first to make sure.
Make sure you print it lying on its side, like it is in the file.
The "Low edge" version is for minimizing screen obstruction on devices with very thin edges around the screen. If you think this might apply to you, print the "edge tester" first to make sure.
SubSite veröffentlicht auch auf
44 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
