Thingiverse
Adjustable Tablet Stand
by SubSite
18
Downloads
12
Likes
0
Makes
A sleek stand that should fit most tablets. Tilt angle adjustable with screw. Prints without supports.
Make sure you print it lying on its side, like it is in the file.
The "Low edge" version is for minimizing screen obstruction on devices with very thin edges around the screen. If you think this might apply to you, print the "edge tester" first to make sure.
Make sure you print it lying on its side, like it is in the file.
The "Low edge" version is for minimizing screen obstruction on devices with very thin edges around the screen. If you think this might apply to you, print the "edge tester" first to make sure.
SubSite also publishes on
45 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
