Thingiverse
Adjustable Tablet Stand
door SubSite
18
Downloads
12
Likes
0
Makes
A sleek stand that should fit most tablets. Tilt angle adjustable with screw. Prints without supports.
Make sure you print it lying on its side, like it is in the file.
The "Low edge" version is for minimizing screen obstruction on devices with very thin edges around the screen. If you think this might apply to you, print the "edge tester" first to make sure.
Make sure you print it lying on its side, like it is in the file.
The "Low edge" version is for minimizing screen obstruction on devices with very thin edges around the screen. If you think this might apply to you, print the "edge tester" first to make sure.
SubSite publiceert ook op
45 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
