Slicer Discord
Alien Hand – 3D printable model from MakerWorld MakerWorld
Other Toys & Games

Alien Hand

11 Downloads
31 Likes
2 Makes
Go to Model
This is what you might call ade-ssistive device - it takes two perfectly good hands to operate one rather feeble (although slightly sinister) one. Inspired by various tentacle designs (http://www.thingiverse.com/thing:6986, http://www.thingiverse.com/thing:10337, http://www.thingiverse.com/thing:206231), each finger prints as a single piece with 12 flexible sections and can be configured in 8,388,608 (give or take) different ways.I've got this version configured as two 4-DOF (degree of freedom) fingers and one 2-DOF thumb. You can actuate particular flexures in a finger by running the tendons through holes in the outside corners, and not activate other flexures by running the tendons through holes in the center. I've biased all three fingers backwards with tendons running along the back side, and that are then attached to rubber bands.And finally, I've mounted the fingers on a palm-gripped platform that lets you use all 10 of your fingers to operate all 10 degrees of freedoms. As you c
Category
Other Toys & Games
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Why?
print-in-place design
Print-in-place
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

LoboCNC also publishes on

313 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection