Slicer Discord
Alien Hand – Modelo 3D imprimible de MakerWorld MakerWorld
Other Toys & Games

Alien Hand

11 Descargas
31 Likes
2 Makes
Ver Modelo
This is what you might call ade-ssistive device - it takes two perfectly good hands to operate one rather feeble (although slightly sinister) one. Inspired by various tentacle designs (http://www.thingiverse.com/thing:6986, http://www.thingiverse.com/thing:10337, http://www.thingiverse.com/thing:206231), each finger prints as a single piece with 12 flexible sections and can be configured in 8,388,608 (give or take) different ways.I've got this version configured as two 4-DOF (degree of freedom) fingers and one 2-DOF thumb. You can actuate particular flexures in a finger by running the tendons through holes in the outside corners, and not activate other flexures by running the tendons through holes in the center. I've biased all three fingers backwards with tendons running along the back side, and that are then attached to rubber bands.And finally, I've mounted the fingers on a palm-gripped platform that lets you use all 10 of your fingers to operate all 10 degrees of freedoms. As you c
Categoría
Other Toys & Games
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
¿Por qué?
diseño print-in-place
Print-in-place
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

LoboCNC también publica en

313 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección