Slicer Discord
Alien Hand – 3D-Druckmodell von MakerWorld MakerWorld
Other Toys & Games

Alien Hand

11 Downloads
31 Likes
2 Makes
Zum Modell
This is what you might call ade-ssistive device - it takes two perfectly good hands to operate one rather feeble (although slightly sinister) one. Inspired by various tentacle designs (http://www.thingiverse.com/thing:6986, http://www.thingiverse.com/thing:10337, http://www.thingiverse.com/thing:206231), each finger prints as a single piece with 12 flexible sections and can be configured in 8,388,608 (give or take) different ways.I've got this version configured as two 4-DOF (degree of freedom) fingers and one 2-DOF thumb. You can actuate particular flexures in a finger by running the tendons through holes in the outside corners, and not activate other flexures by running the tendons through holes in the center. I've biased all three fingers backwards with tendons running along the back side, and that are then attached to rubber bands.And finally, I've mounted the fingers on a palm-gripped platform that lets you use all 10 of your fingers to operate all 10 degrees of freedoms. As you c
Kategorie
Other Toys & Games
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Warum?
Print-in-place-Design
Print-in-place
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

LoboCNC veröffentlicht auch auf

313 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen