Slicer Discord
Alien Hand – 3D-printbaar model van MakerWorld MakerWorld
Other Toys & Games

Alien Hand

11 Downloads
31 Likes
2 Makes
Model downloaden
This is what you might call ade-ssistive device - it takes two perfectly good hands to operate one rather feeble (although slightly sinister) one. Inspired by various tentacle designs (http://www.thingiverse.com/thing:6986, http://www.thingiverse.com/thing:10337, http://www.thingiverse.com/thing:206231), each finger prints as a single piece with 12 flexible sections and can be configured in 8,388,608 (give or take) different ways.I've got this version configured as two 4-DOF (degree of freedom) fingers and one 2-DOF thumb. You can actuate particular flexures in a finger by running the tendons through holes in the outside corners, and not activate other flexures by running the tendons through holes in the center. I've biased all three fingers backwards with tendons running along the back side, and that are then attached to rubber bands.And finally, I've mounted the fingers on a palm-gripped platform that lets you use all 10 of your fingers to operate all 10 degrees of freedoms. As you c
Categorie
Other Toys & Games
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Waarom?
print-in-place ontwerp
Print-in-place
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

LoboCNC publiceert ook op

313 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie