Thingiverse
Camera Holder
door leadinglights
44
Downloads
30
Likes
1
Makes
I have recently been using Octoprint along with webcams on two of my printers but became dissatisfied with the traditions methods of holding the camera - Duck tape, Elastic bands and cardboard boxes. Also, it would be nice to be able to move the camera out of the way to take prints off or do necessary maintenance - and then put the camera back where it was.
In use the camera and arm are held in place by a pair of magnets but can be moved out of the way or even be latched right out of the way by another pair of magnets.
As the STL files are based on specific webcams (Logitech Pro 9000 and Logitech C270) and printers (Prusa 1 and Rostock), this is presented more as something to build your own design on.
Unprinted parts needed:
M8 by 65mm part threaded bolt, (13mm hex head) 2 off
M8 Nut, (13mm hex) 2 off
Magnet, 10mm dia by 2mm thick, 4 off
8mm dia ground steel shaft, length as needed.
M5 by 20mm hex head screw (8mm a/f) for C270 camera holder.
M5 nut (8mm a/f) for C270 ca
In use the camera and arm are held in place by a pair of magnets but can be moved out of the way or even be latched right out of the way by another pair of magnets.
As the STL files are based on specific webcams (Logitech Pro 9000 and Logitech C270) and printers (Prusa 1 and Rostock), this is presented more as something to build your own design on.
Unprinted parts needed:
M8 by 65mm part threaded bolt, (13mm hex head) 2 off
M8 Nut, (13mm hex) 2 off
Magnet, 10mm dia by 2mm thick, 4 off
8mm dia ground steel shaft, length as needed.
M5 by 20mm hex head screw (8mm a/f) for C270 camera holder.
M5 nut (8mm a/f) for C270 ca
leadinglights publiceert ook op
22 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
