Slicer Discord
dfPlayer Bracket – 3D-printbaar model van Thingiverse Thingiverse

dfPlayer Bracket

door bobtidey
51 Downloads
29 Likes
0 Makes
Model downloaden
The dfPlayer is a nice audio module that plays back mp3 files stored on a micro SD card. It is very cheap and gives a good basis for turning spare speakers into music playback devices.

The module contains the SD card socket, the audio playback electronics, stereo headphone outputs, and a mono speaker amplifier. It can be controlled either by local buttons or by commands over a serial interface. I use the module in conjunction with a esp8266 processor to give browser based control. https://github.com/roberttidey/dfPlayer

The module can be tricky to mount as one wants to have access to the SD card slot.

This bracket is designed to make that easier by allowing it to be screwed inot a flat panel. A slot for the SD card needs to be cut out of the panel but then the bracket can be secured with 2 screws to securely hold the dfPlayer in place.

The bracket has a little cut out to allow for air circulation around the power amplifier and it aso has a rear hole to allow a wire to be fe
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, TPU
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie