Slicer Discord
FLAPJACK – 3D-Druckmodell von Thingiverse Thingiverse

FLAPJACK

105 Downloads
63 Likes
1 Makes
Zum Modell
This is a remix of a remix. Original post is a 150g antweight called Blockhead by earthwormjim - https://www.thingiverse.com/thing:2812197

I remixed it to a 1 pound US ant and was super happy with it as a design.
https://www.thingiverse.com/thing:3111090

This a V2 of my design, improving on what I saw in its first 5 fights of the V1 at mass destruction at maker fair NYC.

- my original 180 mah battery conked out after about 90 seconds of full thrust (because math is hard). increasing to 450 mah.
- the v1 flat beater bar accomplished only a few good hits. This is a larger bar and now has an angled attack.
- added a ramp under the bar to get some lift on the opponent to set up a better hit.
- N20 motors can and do easily fail. this design allows N20 to be swapped out much more easily by dropping out of the bottom surface..
- on/off switch changed to be accessed on top side.


BOM of Electronics I crammed in there:
Esc = DasMikro Duel (http://tinyurl.com/ybvkxqxj)
R
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen