Slicer Discord
FLAPJACK – 3D-printbaar model van Thingiverse Thingiverse

FLAPJACK

105 Downloads
63 Likes
1 Makes
Model downloaden
This is a remix of a remix. Original post is a 150g antweight called Blockhead by earthwormjim - https://www.thingiverse.com/thing:2812197

I remixed it to a 1 pound US ant and was super happy with it as a design.
https://www.thingiverse.com/thing:3111090

This a V2 of my design, improving on what I saw in its first 5 fights of the V1 at mass destruction at maker fair NYC.

- my original 180 mah battery conked out after about 90 seconds of full thrust (because math is hard). increasing to 450 mah.
- the v1 flat beater bar accomplished only a few good hits. This is a larger bar and now has an angled attack.
- added a ramp under the bar to get some lift on the opponent to set up a better hit.
- N20 motors can and do easily fail. this design allows N20 to be swapped out much more easily by dropping out of the bottom surface..
- on/off switch changed to be accessed on top side.


BOM of Electronics I crammed in there:
Esc = DasMikro Duel (http://tinyurl.com/ybvkxqxj)
R
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie