Slicer Discord
FLAPJACK – Modelo 3D imprimible de Thingiverse Thingiverse

FLAPJACK

105 Descargas
63 Likes
1 Makes
Ver Modelo
This is a remix of a remix. Original post is a 150g antweight called Blockhead by earthwormjim - https://www.thingiverse.com/thing:2812197

I remixed it to a 1 pound US ant and was super happy with it as a design.
https://www.thingiverse.com/thing:3111090

This a V2 of my design, improving on what I saw in its first 5 fights of the V1 at mass destruction at maker fair NYC.

- my original 180 mah battery conked out after about 90 seconds of full thrust (because math is hard). increasing to 450 mah.
- the v1 flat beater bar accomplished only a few good hits. This is a larger bar and now has an angled attack.
- added a ramp under the bar to get some lift on the opponent to set up a better hit.
- N20 motors can and do easily fail. this design allows N20 to be swapped out much more easily by dropping out of the bottom surface..
- on/off switch changed to be accessed on top side.


BOM of Electronics I crammed in there:
Esc = DasMikro Duel (http://tinyurl.com/ybvkxqxj)
R
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección