Slicer Discord
Floatant Caddy – Modelo 3D imprimible de MakerWorld MakerWorld
Sport & Outdoors

Floatant Caddy

96 Descargas
36 Likes
54 Makes
Ver Modelo
When fishing dry flies, it's useful to have both a powder desiccant (Shimazaki Dry Shake, Loon Top Ride, etc) and a liquid floatant ( Gink, Aquel, etc). Rather than fish them out of pockets, this caddy holds both and clips on to a vest or pack loop. This caddy was designed to fit loon's top ride and aquel floatant, shown below with a short piece of elastic cord and a small carabiner.Knot one side of the cord and pass thru the back of the caddy. Loop around the front and pass thru the second hole and knot.It should fit snuggly below the cap of the Top Ride.After making sure your Top Ride is capped tightly, flip the caddy over and insert the Aquel with its cap off.Then tighten the Aquel cap.Insert the small carabiner (or other attachment: cord, snap swivel, etc) thru the top hole and attach to your vest or pack.
Categoría
Sport & Outdoors
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección