Slicer Discord
Floatant Caddy – 3D-printbaar model van MakerWorld MakerWorld
Sport & Outdoors

Floatant Caddy

96 Downloads
36 Likes
54 Makes
Model downloaden
When fishing dry flies, it's useful to have both a powder desiccant (Shimazaki Dry Shake, Loon Top Ride, etc) and a liquid floatant ( Gink, Aquel, etc). Rather than fish them out of pockets, this caddy holds both and clips on to a vest or pack loop. This caddy was designed to fit loon's top ride and aquel floatant, shown below with a short piece of elastic cord and a small carabiner.Knot one side of the cord and pass thru the back of the caddy. Loop around the front and pass thru the second hole and knot.It should fit snuggly below the cap of the Top Ride.After making sure your Top Ride is capped tightly, flip the caddy over and insert the Aquel with its cap off.Then tighten the Aquel cap.Insert the small carabiner (or other attachment: cord, snap swivel, etc) thru the top hole and attach to your vest or pack.
Categorie
Sport & Outdoors
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie