Thingiverse
Frog Chess
von vegetalko
175
Downloads
208
Likes
0
Makes
Once again back at frogs. :)
"Frog_chess.stl" was printed with 0.2 nozzle at 0.1 layer height this model is better (larger figures, heads and aligment of them is better).
The file ending "04" i tried and printed succesfully with 0.4 nozzle at 0.2 layer height (worser).
Default is 20*20 square under each frog for good fitment on small travel chess boards.
No supports needed
"Frog_chess.stl" was printed with 0.2 nozzle at 0.1 layer height this model is better (larger figures, heads and aligment of them is better).
The file ending "04" i tried and printed succesfully with 0.4 nozzle at 0.2 layer height (worser).
Default is 20*20 square under each frog for good fitment on small travel chess boards.
No supports needed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
