Thingiverse
Frog Chess
door vegetalko
175
Downloads
208
Likes
0
Makes
Once again back at frogs. :)
"Frog_chess.stl" was printed with 0.2 nozzle at 0.1 layer height this model is better (larger figures, heads and aligment of them is better).
The file ending "04" i tried and printed succesfully with 0.4 nozzle at 0.2 layer height (worser).
Default is 20*20 square under each frog for good fitment on small travel chess boards.
No supports needed
"Frog_chess.stl" was printed with 0.2 nozzle at 0.1 layer height this model is better (larger figures, heads and aligment of them is better).
The file ending "04" i tried and printed succesfully with 0.4 nozzle at 0.2 layer height (worser).
Default is 20*20 square under each frog for good fitment on small travel chess boards.
No supports needed
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
