Thingiverse
Frog Chess
por vegetalko
175
Descargas
208
Likes
0
Makes
Once again back at frogs. :)
"Frog_chess.stl" was printed with 0.2 nozzle at 0.1 layer height this model is better (larger figures, heads and aligment of them is better).
The file ending "04" i tried and printed succesfully with 0.4 nozzle at 0.2 layer height (worser).
Default is 20*20 square under each frog for good fitment on small travel chess boards.
No supports needed
"Frog_chess.stl" was printed with 0.2 nozzle at 0.1 layer height this model is better (larger figures, heads and aligment of them is better).
The file ending "04" i tried and printed succesfully with 0.4 nozzle at 0.2 layer height (worser).
Default is 20*20 square under each frog for good fitment on small travel chess boards.
No supports needed
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
