Thingiverse
Hinge
door TinkerLifeProjects
24
Downloads
20
Likes
0
Makes
Originally designed for an ultimaker 2 enclosure I was building.
The hole spacing is 25mm by 30mm
Requires:
1 x 35mm bolt
1/2 x m3 washer (for the removable and fixed design respectively)
There are two versions, one that can be slid apart easily and one that is fixed. Both use a m3 washer (1mm thick) to act as a small bushing.
Best printed with supports - touching build plate
The hole spacing is 25mm by 30mm
Requires:
1 x 35mm bolt
1/2 x m3 washer (for the removable and fixed design respectively)
There are two versions, one that can be slid apart easily and one that is fixed. Both use a m3 washer (1mm thick) to act as a small bushing.
Best printed with supports - touching build plate
TinkerLifeProjects publiceert ook op
9 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
