Thingiverse
jack stand foundry pattern
by tedsykora
14
Downloads
4
Likes
0
Makes
This is a split foundry pattern for mrpete jack stand project.
It is not necessarily the exact same curvature
I printed at 70 percent to yield a stand base of about 3.25 inches
This is just the base
I neglected to put a fillet where the "handles meet the part"
It is not necessarily the exact same curvature
I printed at 70 percent to yield a stand base of about 3.25 inches
This is just the base
I neglected to put a fillet where the "handles meet the part"
tedsykora also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!