Thingiverse
jack stand foundry pattern
von tedsykora
14
Downloads
4
Likes
0
Makes
This is a split foundry pattern for mrpete jack stand project.
It is not necessarily the exact same curvature
I printed at 70 percent to yield a stand base of about 3.25 inches
This is just the base
I neglected to put a fillet where the "handles meet the part"
It is not necessarily the exact same curvature
I printed at 70 percent to yield a stand base of about 3.25 inches
This is just the base
I neglected to put a fillet where the "handles meet the part"
tedsykora veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!