Thingiverse
jack stand foundry pattern
door tedsykora
14
Downloads
4
Likes
0
Makes
This is a split foundry pattern for mrpete jack stand project.
It is not necessarily the exact same curvature
I printed at 70 percent to yield a stand base of about 3.25 inches
This is just the base
I neglected to put a fillet where the "handles meet the part"
It is not necessarily the exact same curvature
I printed at 70 percent to yield a stand base of about 3.25 inches
This is just the base
I neglected to put a fillet where the "handles meet the part"
tedsykora publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!