Thingiverse
jack stand foundry pattern
por tedsykora
14
Descargas
4
Likes
0
Makes
This is a split foundry pattern for mrpete jack stand project.
It is not necessarily the exact same curvature
I printed at 70 percent to yield a stand base of about 3.25 inches
This is just the base
I neglected to put a fillet where the "handles meet the part"
It is not necessarily the exact same curvature
I printed at 70 percent to yield a stand base of about 3.25 inches
This is just the base
I neglected to put a fillet where the "handles meet the part"
tedsykora también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!