Thingiverse
LED remote controller holder
by jumar
0
Downloads
0
Likes
0
Makes
This is my design for LED strips / LED remote controller holder.
I found existing design non optimal. This design holds the remote just tightly enough to prevent wobbling but not too tightly to make it hard to insert/remove the remote.
It has rounded corners for comfort and screw holes for fastening.
Print vertically with supports and a brim to make sure that the part adheres well to the build plate.
I found existing design non optimal. This design holds the remote just tightly enough to prevent wobbling but not too tightly to make it hard to insert/remove the remote.
It has rounded corners for comfort and screw holes for fastening.
Print vertically with supports and a brim to make sure that the part adheres well to the build plate.
jumar also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
