Thingiverse
LED remote controller holder
door jumar
0
Downloads
0
Likes
0
Makes
This is my design for LED strips / LED remote controller holder.
I found existing design non optimal. This design holds the remote just tightly enough to prevent wobbling but not too tightly to make it hard to insert/remove the remote.
It has rounded corners for comfort and screw holes for fastening.
Print vertically with supports and a brim to make sure that the part adheres well to the build plate.
I found existing design non optimal. This design holds the remote just tightly enough to prevent wobbling but not too tightly to make it hard to insert/remove the remote.
It has rounded corners for comfort and screw holes for fastening.
Print vertically with supports and a brim to make sure that the part adheres well to the build plate.
jumar publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
