Thingiverse
LED remote controller holder
por jumar
0
Descargas
0
Likes
0
Makes
This is my design for LED strips / LED remote controller holder.
I found existing design non optimal. This design holds the remote just tightly enough to prevent wobbling but not too tightly to make it hard to insert/remove the remote.
It has rounded corners for comfort and screw holes for fastening.
Print vertically with supports and a brim to make sure that the part adheres well to the build plate.
I found existing design non optimal. This design holds the remote just tightly enough to prevent wobbling but not too tightly to make it hard to insert/remove the remote.
It has rounded corners for comfort and screw holes for fastening.
Print vertically with supports and a brim to make sure that the part adheres well to the build plate.
jumar también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
