Thingiverse
LED remote controller holder
von jumar
0
Downloads
0
Likes
0
Makes
This is my design for LED strips / LED remote controller holder.
I found existing design non optimal. This design holds the remote just tightly enough to prevent wobbling but not too tightly to make it hard to insert/remove the remote.
It has rounded corners for comfort and screw holes for fastening.
Print vertically with supports and a brim to make sure that the part adheres well to the build plate.
I found existing design non optimal. This design holds the remote just tightly enough to prevent wobbling but not too tightly to make it hard to insert/remove the remote.
It has rounded corners for comfort and screw holes for fastening.
Print vertically with supports and a brim to make sure that the part adheres well to the build plate.
jumar veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
