Thingiverse
MP Mini Select printer foot
von lukemillermakes
15
Downloads
4
Likes
0
Makes
I lost the rubber feet one one side of my printer. This meant that it was scratching the surface underneath and there wasn't any airflow underneath.
These little feet allow you to take off 4 of the screws on the bottom plate, put them through the feet, and screw them back. It raises the printer a bit so there is increased airflow.
These little feet allow you to take off 4 of the screws on the bottom plate, put them through the feet, and screw them back. It raises the printer a bit so there is increased airflow.
lukemillermakes veröffentlicht auch auf
5 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
