Thingiverse
MP Mini Select printer foot
door lukemillermakes
15
Downloads
4
Likes
0
Makes
I lost the rubber feet one one side of my printer. This meant that it was scratching the surface underneath and there wasn't any airflow underneath.
These little feet allow you to take off 4 of the screws on the bottom plate, put them through the feet, and screw them back. It raises the printer a bit so there is increased airflow.
These little feet allow you to take off 4 of the screws on the bottom plate, put them through the feet, and screw them back. It raises the printer a bit so there is increased airflow.
lukemillermakes publiceert ook op
6 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
