Thingiverse
MP Mini Select printer foot
15
Download
4
Likes
0
Makes
I lost the rubber feet one one side of my printer. This meant that it was scratching the surface underneath and there wasn't any airflow underneath.
These little feet allow you to take off 4 of the screws on the bottom plate, put them through the feet, and screw them back. It raises the printer a bit so there is increased airflow.
These little feet allow you to take off 4 of the screws on the bottom plate, put them through the feet, and screw them back. It raises the printer a bit so there is increased airflow.
lukemillermakes pubblica anche su
5 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
