Thingiverse
Optocoupler case auto-bedleveling sensor
door bluecake
12
Downloads
9
Likes
0
Makes
This is a little case for the optocoupler wich can be found on aliexpress to put between your sensor for auto-bedlevelling and your motherboard.
It's not a tight fit but you could always use the 2 holes in the pcb to secure the board to the bottom of the case.
It's not a tight fit but you could always use the 2 holes in the pcb to secure the board to the bottom of the case.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
