Thingiverse
Optocoupler case auto-bedleveling sensor
by bluecake
12
Downloads
9
Likes
0
Makes
This is a little case for the optocoupler wich can be found on aliexpress to put between your sensor for auto-bedlevelling and your motherboard.
It's not a tight fit but you could always use the 2 holes in the pcb to secure the board to the bottom of the case.
It's not a tight fit but you could always use the 2 holes in the pcb to secure the board to the bottom of the case.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
