Thingiverse
Optocoupler case auto-bedleveling sensor
por bluecake
12
Descargas
9
Likes
0
Makes
This is a little case for the optocoupler wich can be found on aliexpress to put between your sensor for auto-bedlevelling and your motherboard.
It's not a tight fit but you could always use the 2 holes in the pcb to secure the board to the bottom of the case.
It's not a tight fit but you could always use the 2 holes in the pcb to secure the board to the bottom of the case.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
