Paramotor Modified Tail
von BlackBuck
18
Downloads
13
Likes
0
Makes
Modified design for the tail section of Tom Stanton's original Paramotor design.
Added some 'skids' or support struts because I found that the prop guard would catch on rough ground during a failed launch. This modification makes a break to the prop guard less likely.
I've included the full tail section but also sliced it vertically for 200x200 printers.
30/12/19:
Add a version 2 which now has crossed supports for greater strength and stability
Added some 'skids' or support struts because I found that the prop guard would catch on rough ground during a failed launch. This modification makes a break to the prop guard less likely.
I've included the full tail section but also sliced it vertically for 200x200 printers.
30/12/19:
Add a version 2 which now has crossed supports for greater strength and stability
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
