Paramotor Modified Tail
door BlackBuck
18
Downloads
13
Likes
0
Makes
Modified design for the tail section of Tom Stanton's original Paramotor design.
Added some 'skids' or support struts because I found that the prop guard would catch on rough ground during a failed launch. This modification makes a break to the prop guard less likely.
I've included the full tail section but also sliced it vertically for 200x200 printers.
30/12/19:
Add a version 2 which now has crossed supports for greater strength and stability
Added some 'skids' or support struts because I found that the prop guard would catch on rough ground during a failed launch. This modification makes a break to the prop guard less likely.
I've included the full tail section but also sliced it vertically for 200x200 printers.
30/12/19:
Add a version 2 which now has crossed supports for greater strength and stability
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
