Paramotor Modified Tail
por BlackBuck
18
Descargas
13
Likes
0
Makes
Modified design for the tail section of Tom Stanton's original Paramotor design.
Added some 'skids' or support struts because I found that the prop guard would catch on rough ground during a failed launch. This modification makes a break to the prop guard less likely.
I've included the full tail section but also sliced it vertically for 200x200 printers.
30/12/19:
Add a version 2 which now has crossed supports for greater strength and stability
Added some 'skids' or support struts because I found that the prop guard would catch on rough ground during a failed launch. This modification makes a break to the prop guard less likely.
I've included the full tail section but also sliced it vertically for 200x200 printers.
30/12/19:
Add a version 2 which now has crossed supports for greater strength and stability
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
