Thingiverse

Project #MicroLongRange [3 Inch version]

par Dave_C_FPV

211 Téléchargements

192 Likes

2 Makes

__ABOUT THE DESIGN__
This design is a 3 inch version of my [MicroLongRange](https://www.thingiverse.com/thing:4054381) 4" frame. I decided to put it in a separate post since its not only
shorter arms but also new bottom plate to adapt the angle of the dead cat layout. Just like the 4 inch version this frame
configuration allows you to easily fit an impressive amount of feature in your sub 250 setup:
- GPS for speed, location, return home etc.
- 4K video footage with no props in view
- And independent buzzer for easier post crash recovery even if the battery is ejected
- 3+ miles of range with and 800mW VTX

__FRAME SPEC__
- Max. Prop Size: 3 Inch
- Frame weight: ~ 32 g
- Front Stack: 16x16 only
- Rear Stack: 20x20 only
- Cam mounts: 19mm Micro
- Motor Mounts: 9-12mm 4-hole
- Standoffs: M2x25 and M2x20

__BUILD RECOMMENDATIONS__
The build recommendations for the 3 inch version are basically identical to the 4 inch version except the motors and props obviously.
- **Mo

dave c Dave c fpv DIY Drone drone drone frame fpv FPV quad fpv quadcopter microlongrange quad Quadcopter dave c Dave c fpv DIY Drone drone drone frame fpv FPV quad fpv quadcopter microlongrange quad Quadcopter

Source

Thingiverse

Ce qu'il faut pour imprimer: Débutant Confiance faible

Monobloc

Supports 1/3

Assemblage 0/3

Réglages 1/3

Taille du plateau 0/3

Post-traitement 0/3

Imprimante

FDM / FFF

Format de fichier