![Project #MicroLongRange [3 Inch version] – 3D-printbaar model van Thingiverse](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Fassets%2Fda%2Ff6%2Ffc%2Fa4%2Fb3%2Flarge_display_MicroLongrance_3_Inch_2020-Jan-02_03-17-03AM-000_CustomizedView16409005189_jpg.jpg&w=800&h=800)
Thingiverse
Project #MicroLongRange [3 Inch version]
door Dave_C_FPV
211
Downloads
192
Likes
2
Makes
__ABOUT THE DESIGN__
This design is a 3 inch version of my [MicroLongRange](https://www.thingiverse.com/thing:4054381) 4" frame. I decided to put it in a separate post since its not only
shorter arms but also new bottom plate to adapt the angle of the dead cat layout. Just like the 4 inch version this frame
configuration allows you to easily fit an impressive amount of feature in your sub 250 setup:
- GPS for speed, location, return home etc.
- 4K video footage with no props in view
- And independent buzzer for easier post crash recovery even if the battery is ejected
- 3+ miles of range with and 800mW VTX
__FRAME SPEC__
- Max. Prop Size: 3 Inch
- Frame weight: ~ 32 g
- Front Stack: 16x16 only
- Rear Stack: 20x20 only
- Cam mounts: 19mm Micro
- Motor Mounts: 9-12mm 4-hole
- Standoffs: M2x25 and M2x20
__BUILD RECOMMENDATIONS__
The build recommendations for the 3 inch version are basically identical to the 4 inch version except the motors and props obviously.
- **Mo
This design is a 3 inch version of my [MicroLongRange](https://www.thingiverse.com/thing:4054381) 4" frame. I decided to put it in a separate post since its not only
shorter arms but also new bottom plate to adapt the angle of the dead cat layout. Just like the 4 inch version this frame
configuration allows you to easily fit an impressive amount of feature in your sub 250 setup:
- GPS for speed, location, return home etc.
- 4K video footage with no props in view
- And independent buzzer for easier post crash recovery even if the battery is ejected
- 3+ miles of range with and 800mW VTX
__FRAME SPEC__
- Max. Prop Size: 3 Inch
- Frame weight: ~ 32 g
- Front Stack: 16x16 only
- Rear Stack: 20x20 only
- Cam mounts: 19mm Micro
- Motor Mounts: 9-12mm 4-hole
- Standoffs: M2x25 and M2x20
__BUILD RECOMMENDATIONS__
The build recommendations for the 3 inch version are basically identical to the 4 inch version except the motors and props obviously.
- **Mo
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
