Thingiverse
Ring set
por Seanamatic
26
Descargas
18
Likes
0
Makes
This is a set of four rings I designed in Fusion 360! It was just a small test for rings that I could cast later in pewter and wear!
If using Cura, I would print on the best settings you can. I printed with 10% infill and it works just fine, but I would suggest 40-50 for long-term wear.
Enjoy!
If using Cura, I would print on the best settings you can. I printed with 10% infill and it works just fine, but I would suggest 40-50 for long-term wear.
Enjoy!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
