Thingiverse
Ring set
di Seanamatic
26
Download
18
Likes
0
Makes
This is a set of four rings I designed in Fusion 360! It was just a small test for rings that I could cast later in pewter and wear!
If using Cura, I would print on the best settings you can. I printed with 10% infill and it works just fine, but I would suggest 40-50 for long-term wear.
Enjoy!
If using Cura, I would print on the best settings you can. I printed with 10% infill and it works just fine, but I would suggest 40-50 for long-term wear.
Enjoy!
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
