Thingiverse
Ring set
door Seanamatic
26
Downloads
18
Likes
0
Makes
This is a set of four rings I designed in Fusion 360! It was just a small test for rings that I could cast later in pewter and wear!
If using Cura, I would print on the best settings you can. I printed with 10% infill and it works just fine, but I would suggest 40-50 for long-term wear.
Enjoy!
If using Cura, I would print on the best settings you can. I printed with 10% infill and it works just fine, but I would suggest 40-50 for long-term wear.
Enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
